Stumped after CSb config

[Kp]

BAH...I dont understand why it wont work...Everything is correct, could I perhaps send one of yall my code?

It rather seems you've been doing that already.  Perhaps you should follow the suggestions I've made a couple times now, debugprint all unknown values, and see if anything comes up?

[Mr.Sasquatch]

I did do that...Yet still no connection   Umm can I try sending you my code?

[Kp]

I did do that...Yet still no connection   Umm can I try sending you my code?

Of course it didn't connect.  That suggestion was only so you could see *what* was happening; unknown problems are difficult to fix.  You can try sending me your code, but I can't guarantee that any good will come of it.

[CrAz3D]

Take out the

With CleanSlateBot1

As trust(hismajesty) already stated you are being redundant in having With CSB1 & CSB1.***

[Mr.Sasquatch]

So instead of sayng CSB1.Username="sas"...I shout just put .username="sas" correct?

[hismajesty]

So instead of sayng CSB1.Username="sas"...I shout just put .username="sas" correct?

If you're going to use the

Code Select Expand

With CleanSlateBot1

[CaPSuLeS]

I don't suggest using that all. Just have it do every time you connect
with the command button. Hence the:

Code:
Private Sub command-button_Click()

Also, make sure your BNLS ID is valid and all that debugging stuff.
As they mentioned before, use the debebugger. See what's wrong. You can also try sending the code to my e-mail at [email protected] and let me see what I can do.

[hismajesty]

I don't suggest using that all.

Aye?